The 2090-XXNPMP-16S90 cable is an Allen-Bradley Bulletin 2090 motor power cable. The length of this cable is 90 meters. One end of the 2090-XXNPMP-16S90 cable which connects to motors has a bayonet connector. This cable can be used when a Kinetix MPL motor with a bayonet connector is replaced with the same type of motor with a DIN connector. In such scenarios, the bayonet connector on the 2090-XXNPMP-16S90 cable connects to the bayonet receptacle on the 0.5-meter long power transition cables. The other end of the transition cable with a DIN connector connects to the motor. The drive end of the 2090-XXNPMP-16S90 cable comes with flying leads. There are 4 wires inside the power cable. Any unused power wires on the 2090-XXNPMP-16S90 cable should not be connected. Unused wires can be trimmed to prevent accidental contact with wire shields or wires or with a ground or earth connection.

The 2090-XXNPMP-16S90 cable installers should ensure that the drive power is disabled before the cable connections are made and before the cables are disconnected. Motor motion or arcing can occur if the cable connection or disconnection is performed when the drive power is enabled. These recommended precautions should also be followed to prevent injury to the users and damage to the equipment. The 2090-XXNPMP-16S90 cable is a standard non-flex cable. It is compatible with the Kinetix MP series motors and the 1326AB series motors. The size of the power conductors inside the cable is 16 AWG. The voltage rating of the power conductors is 600 Volts. The color of the cable jacket is black. The cable jacket is made of industrial grade thermoplastic elastomer.